Epson L200/L201 Service manual

This Epson L200/L201 Service manual, consists of the following chapters, is intended for repair service personnel and includes information necessary for properly performing maintenance and servicing the product. Chapter 1. DISASSEMBLY / REASSEMBLY Describes the disassembly/reassembly procedures for main parts/units of the product, and provides the standard operation time for servicing the product. Chapter 2. ADJUSTMENT Describes the required adjustments for servicing the product. Chapter 3. MAINTENANCE Describes maintenance items and procedures for servicing the product. Chapter 4. APPENDIX Provides the following additional information for reference: Power-On Sequence, Connector Summary, Troubleshooting. Various symbols are used throughout this manual either to provide additional information on a specific topic or to warn of possible danger present during a procedure or an action. Pay attention to all symbols when they are used, and always read explanation thoroughly and follow the instructions.

All safety procedures described here shall be strictly adhered to by all parties servicing and maintaining this product. Strictly observe the following cautions. Failure to comply could result in serious bodily injury or loss of life. Always disconnect the product from the power source and peripheral devices when servicing the product or performing maintenance. When performing works described in this manual, do not connect to a power source until instructed to do so. Connecting to a power source causes high voltage in the power supply unit and some electronic components even if the product power switch is off. If you need to perform the work with the power cable connected to a power source, use extreme caution to avoid electrical shock. Strictly observe the following cautions. Failure to comply may lead to personal injury or loss of life. Always wear protective goggles for disassembly and reassembly to protect your eyes from ink in working. If any ink gets in your eyes, wash your eyes with clean water and consult a doctor immediately. When using compressed air products; such as air duster, for cleaning during repair and maintenance, the use of such products containing flammable gas is prohibited.

Strictly observe the following cautions. Failure to comply may lead to personal injury or damage of the product. Repairs on Epson product should be performed only by an Epson certified repair technician. No work should be performed on this product by persons unfamiliar with basic safety knowledge required for electrician. The power rating of this product is indicated on the serial number/rating plate. Never connect this product to the power source whose voltages is different from the rated voltage. Replace malfunctioning components only with those components provided or approved by Epson; introduction of second-source ICs or other non-approved components may damage the product and void any applicable Epson warranty. In order to protect sensitive microprocessors and circuitry, use static discharge equipment, such as anti-static wrist straps, when accessing internal components. Do not tilt this product immediately after initial ink charge, especially after performing the ink charge several times. Doing so may cause ink to leak from the product because it may take some time for the waste ink pads to completely absorb ink wasted due to the ink charge. Never touch the ink or wasted ink with bare hands. If ink comes into contact with your skin, wash it off with soap and water immediately. If you have a skin irritation, consult a doctor immediately.

Download Epson L200/L201 Service manual here

Tweet