Xerox Phaser 3250 Service Manual

The following Xerox Phaser 3250 Service Manual instructions are for use by qualified service personnel only. To avoid personal injury, do not perform any servicing other than that contained in the operating instructions, unless you are qualified to do so. Various terms are used throughout this manual to either provide additional information on a specific topic or to warn of possible danger present during a procedure or action. Be aware of all symbols and terms when they are used, and always read Note, Caution, and Warning statements. A note indicates an operating or maintenance procedure, practice or condition that is necessary to efficiently accomplish a task. A note can provide additional information related to a specific subject or add a comment on the results achieved through a previous action. A caution indicates an operating or maintenance procedure, practice or condition that, if not strictly observed, results in damage to, or destruction of, equipment.

For 115 VAC printers, do not apply more than 127 volts RMS between the supply conductors or between either supply conductor and ground. For 230 VAC printers, do not apply more than 254 volts RMS between the supply conductors or between either supply conductor and ground. Use only the specified power cord and connector. This manual assumes that the reader is a qualified service technician. Plug the three-wire power cord (with grounding prong) into a grounded AC outlet only. If necessary, contact a licensed electrician to install a properly grounded outlet. If the product loses its ground connection, contact with conductive parts may cause an electrical shock. A protective ground connection by way of the grounding conductor in the power cord is essential for safe operation. Turning the power Off using the power switch does not completely deenergize the printer. You must also disconnect the power cord from the printer’s Alternating Current (AC) inlet. Disconnect the power cord by pulling the plug, not the cord. Disconnect the power cord in the following cases: If the power cord or plug is frayed or otherwise damaged, If any liquid or foreign material is spilled into the product, if the printer is exposed to any excess moisture, if the printer is dropped or damaged, if you suspect that the product needs servicing or repair, whenever you clean the product.

Xerox Phaser 3250 Service Manual tables of content : general information, theory of operation, error messages and codes, general troubleshooting, adjustments and calibrations cleaning and maintenance, service parts disassembly, parts list, plug/jack and wiring diagrams, reference, phaser 3250 menu map, updating firmware, resetting firmware, acronyms and abbreviations.

Download Xerox Phaser 3250 Service Manual here

Tweet