HP 8116A Service Manual

This HP 8116A Service Manual applies directly to the serial number of the instrument 3134G 11521. If your instrument has a higher serial number, see Appendix C that contains manual changes for subsequent instruments and corrections to the manual. Be sure to examine this supplement to see the changes that apply to your instrument and record these changes in the manual. If your instrument has a lower serial number, refer to Appendix B which contains manual changes to previous instruments. The new editions are complete revisions of the manual. Packages update, which emits between editions, contain additional pages and replacement to be merged in the manual by the customer. The date on the cover and the back cover of the manual only changes when a new edition is published. When it is reprinted Edition, incorporates all updates prior to the Edition. No information is incorporated into a new edition unless it appears on a previous update. This product has been designed and tested in accordance with international safety requirements. To ensure safe operation and maintain the safe product, must be account information, cautions and warnings contained in this manual.

This manual describes the following procedures for programmable HP 8116A 50 MHz pulse generator: installation operation programming performance test w w w w maintenance a version of microfilm of this manual setting is available in slides of microfilm from 4 x 6 inches (see the title for the order number). Microfiche package also includes the last supplement manual changes and all relevant service notes. In the back of the instrument, there is a plate serial number (Figure 1-1). The first four digits change only when there is a significant change in the instrument, the last five digits are sequentially assigned to the instruments. This manual applies directly to the instrument with serial number mentioned on the cover. For instruments with higher serial numbers, see blades of manual exchange in Appendix C. To keep this updated manual, Hewlett-Packard recommends to periodically request the latest manual supplement citing the part number and the date of printing of this manual, both of which appear on the front cover.

All the specifications of the following sections describe the guaranteed performance of the instrument: timing parameters of output waveform characteristics all specifications are applied with a load of 50 R, after a 30-minute warm-up period and are valid for ambient temperature in the range from 15OC to 35OC. See the section General characteristics of this chapter for the reduction factor of performance to be used outside this temperature range (within the operating range specified by 0 ° C to 55 ° C). All performance properties listed in the following sections describe typical performance figures that are not guaranteed: w shooting modes of control inputs and outputs w general features additional modes.

Table of contents HP 8116A Service Manual

Introduction

Specifications

Installation 

Operating

Operating Examples

Programming

Programming Examples

Testing Performance

Adjustment Procedures

Introduction to Servicing

Instrument Overview and Troubleshooting Guide

Servicing the Power Supply

Servicing the VCO and Width Generator

Servicing the Shaper and Output Amplifier

Servicing the Standard Control Board

Servicing the Option 001 Control Board

Servicing the Microprocessor and Front panel

Replaceable Parts

Backdating

Updating Introduction

Sales and Service Office

Download HP 8116A Service Manual

Tweet