Toshiba 2060 2860 Service Manual

Transport/install Copier, use two people and be sure to use the positions as shown below. The Toshiba 2060 2860 copier is quite heavy and weighs approximately 73 kg (161 lbs), therefore pay close attention when handling. (2870: 84 kg).  Installation; be sure to use a dedicated outlet with an AC 115V / 15A (220V, 240V / 10A) or more for their power supply.  The copier must be grounded for safety reasons. It never connects ground to a pipe of gas on a water pipe. Select a suitable location for the installation. Avoid excessive heat, high humidity, dust, vibrations and direct sunlight. Also provides adequate ventilation as the copier emits a small amount of ozone. To ensure a suitable work for the operation of copying, keep a minimum distance of 80 cm (32 ") left, 80 cm (32 '') to the right and 10 cm (4 ") on the back.

Service Toshiba 2060 2860 machines; Basically, be sure to turn off the main switch and disconnect the power cable during the service. Make sure not to touch sections of the high-temperature exposure lamp, the fusing unit, wet heater and its periphery. Make sure not to touch the high voltage transformer and high voltage as the Chargers sections. Make sure not to touch the rotating sections/operation, such as gears, belts, pulleys, etc. When performing maintenance of the machines the main switch is on, be sure not to touch active sections, as the terminal of the lamp, etc. Measuring instruments and tools.

Main parts of the security service; Switch, switch the door, fuse, thermostat, thermal fuse, Thermistor, etc. are particularly important for safety. Be sure to use/install correctly. Warning label; Be sure to check the nameplate and caution labels as "Unplug the power cord during operation", "Hot Area", etc. to see if there is dirt on its surface or if they are sticking properly to the copier during the service. Disposal of consumables/packing materials; In terms of recovery and disposal of the Copier, consumable parts, supplies, packaging materials, follow the regulations or relevant local standards.

When parts are dismantled, reassembly is basically the reverse of the disassembly unless stated otherwise herein or other related documents. Be careful not to return to mount small parts such as screws, washers, pins, "E" rings, washers, toothed in the wrong places. Basically, the machine must not be operated with any parts removed or dismantled. Precautions against static electricity; The PC card should be stored in a bag anti-electrostatic and manipulated carefully with a bracelet since it printed circuits may be damaged due to static electricity.

The display unit consists of key for operation switches/selection of copier in each mode, LEDs and an LCD screen that displays the status messages of the Copier. Particularly, when the attention of operator it is recommended, a graphic symbol lights up or flashes and displayed the message indicating this condition. Construction of drive system; The drive system consists of a drum (cleaning unit), a unit from developing the unit, a tape transport, a heat roller, a roll of output, a transport roller, a cassette feed roller and roller alignment. The drive system is powered by the main engine.

Download Toshiba 2060 2860 Service Manual

Tweet